ComfortVu™ BACnet Thermostat Model Standard TB-HM (Line voltage)Carrier Proprietary and Confidential CARRIER CORPORATION ©2020
Installation and Operation Guide All rights reserved
6
P75 – VFS High speed differential
P76 – Fan VFS Low limit in cooling
P77 – Fan VFS High limit in cooling
P78 – Fan VFS Low limit in heating
P79 – Fan VFS High limit in heating
P83 – View T2 temperature sensor readings
P84 – View T3 temperature sensor readings
P85 – Deice in cool – cut-in temperature
P86 – Deice in cool – cut-out temperature
P87 – Deice in heat time
P88 – Deice in heat break time
P89 – Deice in heat – cut-in temperature
P90 – Deice in heat – cut-out temperature
P91 – Compressor delay
P98 – Display set point only (hide room temperature)
P99 – One or Two set points
P101 – Screen dimming delay
P107 – Weekly program configuration
P108 – Weekly program - events per day
P109 – Weekly program event configuration
P111 – PIR Sensitivity
P114 – Cool PID Kp
P115 – Heat PID Kp
P116 – Cool PID Ki
P117 – Heat PID Ki
P118 – Cool PID Kd
P119 – Heat PID Kd
P122 – Cool Proportional output threshold time
P123 – Heat Proportional output threshold time
P160 – Minimum compressor ON time
P161 – Minimum compressor OFF time
P170 – Economizer low limit temperature
P193 – Display switching time (between temp and hum)
P194 – Humidity differential band
P195 – Humidity sensor reading offset
P196 – Dead zone between humidification and dehumidification
P197 – Humidity setpoint
P198 – Not in use
P200 – Restore defaults
Press the [On/Off] button or wait 60 seconds to return to normal display.
To Next Page
Loading...
