ComfortVu™ BACnet Thermostat Model Standard TB-HM (Line voltage)Carrier Proprietary and Confidential CARRIER CORPORATION ©2020
Installation and Operation Guide All rights reserved
16
Days
5. Press the [C/F-Prog] button again. The DAYS will flash.
6. Use the [+] or [-] buttons to select the day.
7. If Technician Setting P107 is not set to “00” (program is enabled), press the [C/F–Prog]
button to enter programming procedure. Be sure to follow the right programming
procedure, suitable for the program type and features selected by Technician Settings.
Section C – “EU Type”
Section D – “US Type”
Otherwise, press the [C/F-Prog] button to return to normal display.
Adjusting “EU type” daily programs
Start time
1. Press the [C/F–Prog] button. The programmed weekday(s), “Prog 1” indicating the first
program event of the day and the word “Start” will appear on display.
The HOURS will flash.
Note: If this is the first time a program is being set, the symbols “--“ will flash.
2. Use the [+] and [-] buttons to adjust the start time hours of the first event.
3. Press the [C/F–Prog] button again. The MINUTES will flash.
4. Use the [+] and [-] buttons to adjust the start time minutes of the first event.
Stop time
5. Press the [C/F – Prog] button again. T the word “Stop” will appear on display, and the
HOURS will flash.
6. Use the [+] and [-] buttons to adjust the stop time hours of the first event
To Next Page
Loading...
