ComfortVu™ BACnet Thermostat Model Standard TB-HM (Line voltage)Carrier Proprietary and Confidential CARRIER CORPORATION ©2020
Installation and Operation Guide All rights reserved
18
System mode and fan speed
5. Press the [C/F–Prog] button again. The system MODES will flash.
6. Use the [+] and [-] buttons to select the system mode of the first event
7. Press the [C/F–Prog] button again. The FAN SPEEDS will flash.
8. Use the [+] and [-] buttons to select the fan speed of the first event.
Setpoint
1. Press the [C/F – Prog] button again. The setpoint will flash.
Note: If the thermostat is configured to have two setpoints,
first adjusts the setpoint for cooling and then the setpoint for heating.
2. Use the [+] and [-] buttons to adjust the setpoint of the first event.
Follow the steps above for the other schedule events of the same daily period (P2 for two events per day, or
P2, P3 and P4 for four events per day).
Follow the steps above for all daily periods.
To Next Page
Loading...
