18
Viewing Reminder Status
You can quickly view the status of your reminders on the thermostat using the Reminder Status screen. The reminder status is displayed as a
percentage of time used based on your reminder settings.
On the Thermostat:
S Touch Menu > Alerts > Reminder Status
Configuring Reminders & Alert Preferences
Your thermostat has several types of alerts which can enabled and customized based on your preferences.
NOTE: Only the options relevant to your heating and cooling system will be shown.
On Thermostat:
1. Touch Menu > Alerts > Preferences
2. Configure each reminder/alert setting as needed.
On Web Portal:
1. Select Reminders & Alerts tile.
2. Touch Preferences.
3. Configure each reminder/alert setting as needed.
Service Reminder
Generates a reminder that regularly scheduled maintenance of your heating and cooling system is required.
You can adjust:
S Enable/Disable: Configures whether or not to generate an alert.
S A duration between scheduled maintenance of 1 month and 12 months.
S The date maintenance was most recently performed.
Filter Reminder
Generates a reminder that indicates it is time to clean or replace your filter.
You can adjust:
S Enable/Disable: Configures whether or not to generate an alert.
S Units: Adjust how the duration between filter changes is calculated. Select months or hours your heating and cooling system operated.
S Duration between filter changes ranging between 1 month -- 12 months (month duration) or 800 hours -- 7200 hours (operation hours
duration)
S The date your filter was last changed.
Ventilator Filter Reminder
Generates a reminder that indicates it is time to clean or replace your ventilator filter.
You can adjust:
S Enable/Disable: Configures whether or not to generate an alert.
S Units: Adjust how the duration between filter changes is calculated. Select months or hours your heating and cooling system operated.
S Duration between filter changes ranging between 1 month -- 12 months (month duration) or 800 hours -- 7200 hours (operation hours
duration).
S The date your filter was last changed.
UV Lamp Reminder
Generates a reminder that it is time to replace the UV bulb.
You can adjust:
S Enable/Disable: Configures whether or not to generate an alert.
S Units: Adjust how the duration between UV bulb changes is calculated. Select months or hours your heating and cooling system operated.
S Duration between UV bulb changes ranging between 1 month -- 12 months (month duration) or 800 hours -- 7200 hours (operation hours
duration)
S The date your UV bulb was last changed.
Low Temperature Alert
When enabled, an alert will be sent if your home’s temperature reaches this setting. You can adjust:
To Next Page
Loading...
