16
A13118
5.3. Indoor Evaporator Selection
If a furnace is installed with a variable capacity heat pump, a screen will appear to
select the installed indoor evaporator coil. This selection is used to adequately
calculate the refrigerant charge required while in the heat pump charging screens
under the Heat Pump Checkout menu (See page 44). Select “other” for non-- Carrier
evaporators.
5.4. Electric Heater Selection
If the indoor equipment is a fan coil, the control will display “Searching for heater”
until one is found. If the electric heater is not self-- identifying, the select heater
screen will appear. Touch the appropriate heater size; then, touch SELECT.
To Next Page
Loading...
