High Wall Type
Installation Manual
–21–
10 Applicable Controls
A wired remote control is necessary for this function. This function cannot be operate with a wireless remote
control.
REQUIREMENT
• When this air conditioner is used for the first
time, it takes approx. 5 minutes until the remote
control becomes available after power-on. This
is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 to 10 minutes until the
remote control becomes available.
<When power is turned on for the second (or
later) time>
It takes approx. 3 to 10 minute until the remote
control becomes available.
• Normal settings were made as factory default.
Change the indoor unit settings as required.
• Use the wired remote control to change the
settings.
Changing applicable control
setting
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Stop the air conditioner before making settings.)
Procedure 1
Push button and temp. setup button
simultaneously for 4 seconds or more.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push button to
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote control is accepted
for a while after button is pushed.)
(While air conditioners are operated under the
group control, “ ” is displayed first.
When button is pushed, the indoor unit
number displayed following “ALL” is header unit.)
* The settings cannot be changed using the
wireless remote control, simple wired remote
control, or central control system. Therefore,
install the wired remote control to change the
settings.
Approx. 5 to 10 minutes
Power
on
“SETTING”
flashes
“SETTING”
goes out
Remote
control is
available
Approx. 3 to 10 minutes
Power
on
“SETTING”
flashes
“SETTING”
goes out
Remote
control is
available
1
6
1
3
2
5
4
(* Display content varies with the
indoor unit model.)
21-EN
+001111053901_00Ta.book Page 21 Monday, January 17, 2011 11:35 AM
To Next Page
Loading...
Need help?
General
