Carrier Performance TP-PRH-A - Set Thermidistat Control Configuration; Configuration Options Summary

24
Set Thermidistat Control Configuration
Configuration options enable the installer to configure the Thermidistat Control for
a particular installation. Most are not presented to the homeowner and therefore
must be properly set by the installer. (Only those marked with an asterisk * below
are available to the homeowner.) The homeowner configurations are described in
the owner’s manual. A special procedure allows entry into the configuration mode.
Selections can be made while in configuration mode. Description of each selection
and how to use the configuration mode follows.
CONFIGURATION OPTIONS -- SUMMARY
Option 01 — Equipment Type
Option 02 — Clean Filter Timer Adjustment
Option 03* — Fahrenheit/Centigrade Selection
Option 04 — Fan (G) on with W/W1 Selection
Option 05 — Room Air Temperature Sensing (programmable
models only)
Option 06 — Cooling Lockout Below 55_F/13_C Selection (only
available if outdoor air sensor is present)
Option 07 — Zoning
Option 08 — Auxiliary Heat Lockout Temperature Setting (only
available when heat pump is used and when
outdoor air temperature sensor is present)
Option 09 — Heat Pump Lockout Temperature Balance Point (only available
when outdoor air temperature sensor is present)
Option 10 — Reversing Valve