– 9 –
Installation Manual
For first use
It takes some time before the remote control becomes operable when the remote control is used for the first time.
This is not a malfunction.
<When the power is turned on for the first time after installation>
It takes about 5 minutes before the remote control becomes operable.
<When the power is turned on from the second time>
It takes about 1 minute before the remote control becomes operable.
Note
For the operation of switching the room temperature sensor or the settings of the test operation, refer to the page
20.
Power on
“ ” flashes
“ ”
disappears
To Next Page
Loading...
