– 28 –
EN
Installation Manual
5. Setting louver position
The louver indication setting can be changed.
1 Push the [ ∧ ] / [ ∨ ] button to select
“5. Setting louver position”, then push the
“ Set” [
F2] button.
Æ“Impossible” is displayed in the case of a model
for which the wind direction cannot be set.
Æz is displayed for the selected item.
2 Push the [ ∧ ] / [ ∨ ] button to select
an item on the “Field position indication”
screen.
The highlighted item can be set.
ÆMove ż with the “ ←z” [ F1] /
“
z→” [ F2] button to set the
setting.
3 After setting each item, push the “MENU”
[
MENU] button to confirm the changes
to the settings.
Change the flap position indication for when swinging is cancelled in [Fixed position
indicator].
ÆWhen “ON” is selected, the louver stops and the indication becomes as shown on the right
when swinging is cancelled.
(Factory default)
ÆWhen “OFF” is selected, the stop position and indication becomes as shown on the right
after swinging is cancelled.
Change the louver operation direction indication in [Operation mode].
ÆWhen “Up/Down” is selected, the louver operation direction indication becomes as shown
on the right.
(Factory default)
ÆWhen “Left/Right” is selected, the louver operation direction indication becomes as shown
on the right.
This can be used with a model whose louver moves left and right.
ON / OFF
Up/Down / Left/Right
Setting louver position
Return Fix
1.Fixed position indication
2.Operation mode
To Next Page
Loading...
