Carrier RBC-AMS54E-UL - Executing Test Mode

– 21 –
Installation Manual
1 Push the [ ∧ ] / [ ∨] button to select
“1. Test mode” on the “Field setting menu”
screen, then push the “ Set”
[
F2] button.
ÆPushing the “ Yes” [ F1] button
sets the test mode and the screen returns to the
“Field setting menu” screen.
Push [ CANCEL] twice, the screen (2)
appears.
2 Push the [ ON / OFF] button to start the
test mode. The screen (1) shown in the left
appears. (The screen (2) appears when the
operation is stopped.)
ÆPerform the test mode in the “Cool” or “Heat”
mode.
ÆTemperature setting cannot be adjusted during
the test mode.
ÆCheck codes are displayed as usual.
3 When the test mode is finished, push the
[ ∧ ] / [ ∨] button to select “1. Test
mode” on the “Field setting menu” screen,
then push the “ Set” [
F2]
button.
The screen (3) appears.
ÆPushing the “ Yes” [ F1] button
stops the test mode screen and continues the
normal operation.
NOTE
The test mode stops after 60 minutes and the screen
returns to the normal / detailed display.
1.Test mode
2.Register service info.
3.Alarm history
4.Monitor function
5.Setting louver position
Field setting menu(1/2)
Return
Set
Set
Yes
Return
Test mode start.
NoYes
Test mode
Test
(1)
Room A
12:00
Mode
Fan Speed
Cool
Set
Yes
Test
(2)
Room A
12:00
Return
Test mode stop.
NoYes
Test mode
(3)