3 4
Function Buttons
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use The Basic/Advance Functions section of
this manual.
NOTE：Please do not select HEAT mode if the machine you purchased is cooling only
type. Heat mode is not supported by the cooling only appliance.
NOT SURE WHAT A FUNCTION DOES?
Refer to the How to Use Basic Functions
and How to Use Advanced Functions
sections of this manual for a detailed
description of how to use your air conditioner.
SPECIAL NOTE
Button designs on your unit may differ
slightly from the example shown.
If the indoor unit does not have a particular
function, pressing that function s button on
the remote control will have no effect.
TIPS FOR USING REMOTE CONTROL
INSERTING AND REPLACING BATTERIES
INSTALLING REMOTE CONTROL HOLDER
Your air conditioning unit comes with two
AAA batteries. Put the batteries in the
remote control before use:
1. Remove the back cover from the remote
control, exposing the battery compartment.
2. Insert the batteries, paying attention to
match up the (+) and (-) ends of the
batteries with the symbols inside the
battery compartment.
3. Install the back cover on.
The remote controller can be attached to a wall
or stand by using a remote controller holder
(optional part, not supplied with the unit).
Before installing the remote controller, check
that the air conditioner receives the signals
properly.
the remote controller in the holder.
1.
2. Install the holder with two screws.
3. Put
BATTERY NOTES
For optimum product performance:
Do not mix old and new batteries, or
batteries of different types.
Do not leave batteries in the remote control
if you don t plan on using the device for
more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for
proper disposal of batteries.
,
,
HANDLING THE REMOTE CONTROLLER
Remove the back cover
to install batteries
Put the remote controller
in the holder.
Mode Fan
TimerTimer
Follow
me
LED
Self
clean
Turbo
Fresh
ON/OFF
FAN
ON/OFF
Turns the unit on or off
MODE
Scrolls through operation
modes as follows:
AUTO
g
COOL
g
DRY
g
HEAT
g
FAN
ECO/SLEEP
TURBO/FRESH
Enables unit to reach preset
temperature in shortest
possible time. If hold down
this button for 2 seconds,
the Fresh feature is activated.
TIMER
Sets timer to turn unit on
and off(see How to Use
Basic Functions for
instructions)
SWING
SWING
Starts and stops horizontal
louver movement.
Detects the people activities
in the room.
LED
Turns indoor unit s LED
display on and off.
,
FOLLOW ME
SELF CLEAN
Starts and stops the unit
self clean feature.
Starts and stops energy
efficient feature. If hod
down this button for
more than 2 seconds,
the sleep feature is
activated.
Temperature sensing and
room temperature display
button.
Starts and stops vertical
louver movement.
,
INTELLIGENT EYE
Selects fan speeds in
the following order:
AU% gg 20%
60%
40%
80%
F%(100%).
g
g
g
Press the Adjust
or button to increase
/decrease the fan
speed in 1% increments.
The remote control must be used within 8
meters of the unit.
The unit will beep when remote signal is
received.
Curtains, other materials and direct
sunlight can interfere with the infrared
signal receiver.
Remove batteries if the remote control
will not be used more than 2 months.
Prevent any liquid from falling into the
remote controller.
If other electrical appliances react to the
remote controller, either move these
appliances or consult your local dealer.
TEMP
TEMP
Increases temperature in
O O
1 F(0.5 C) increments for
each press. If pressing
and holding down this
button, the temperature
O O
will increase in 1 F(1 C)
increments.
Max. Temperature is
O O
86 F(30 C).
Decreases temperature
O O
in 1 F(0.5 C) decrements
for each press. If pressing
and holding down this
button, the temperature
O O
will decrease in 1 F(1 C)
decrements.
Min. temperature is
O O
60 F(16 C).
Model: RG66B4(2H)/BGEF
To Next Page
Loading...
