9
STEP 4. INSTALL YOUR CARRIER
®
THERMOSTAT
1. Separate front display and mounting back plate of thermostat by
pressing the thumb release at the top of the thermostat and carefully
snap apart.
A150220
2. Gently pull the wires through the hole in the back plate.
3. Center the wires in the back plate.
4. Mark four mounting holes on the wall with a pencil.
5. Drill mounting holes on the pencil marks with a 3/16” drill bit.
6. Insert the plastic drywall anchors into the wall. Use the screws pro-
vided to secure the back plate to the wall.
To Next Page
Loading...
