Operation & Service Manual
Carrier Transicold Europe 31/03/07 Viento - Installation/Rev- #40/54
MANDATORY BEFORE ANY ELECTRICAL OPERATION.
DISCONNECT THE VEHICLE BATTERY: Remove the battery ground (-), the positive battery (+)
and lock-out.
1. Move along hoses and battery harness to the compressor
and vehicle battery.
2. Attach regularly the harness with plastic tie-wraps and
base tie-wraps onto the chassis.
3. Insulate the hole with silicon.
RECOMMENDATIONS
Protect or move the harness away from
metallic corners of the chassis.
Avoid connecting the harness to/or in contact
with heating source.
Avoid connecting the harness to parts that
may cause vibrations.
Do not secure the unit harness to the vehicle
harness or piping
Avoid drilling the vehicle frame.
Installation Compressor connection
To Next Page
Loading...
