Operation & Service Manual
Carrier Transicold Europe 31/03/07 Viento - Installation/Rev- #44/54
1. Route the ignition cable to the vehicle fuse box.
2. Connect the white wire onto the fuse holder supplied in the
mounting kit (1A).
3. Refer to the corresponding mounting kit instruction to
connect the +12Vdc ignition live.
4. Cut the battery harness to the required length.
5. Strip the + battery (35mm
2
red) and the fuse holder for the
+ microprocessor positive.
6. Using a crimping tool, install the (125A) fuse supplied with
the mounting kit.
NOTE : Soft-solder is recommended.
Installation Battery & ignition key harness fitting
To Next Page
Loading...
