Carrier WTC-RCI - User Manual

1
Room Control Interface
WTC-RCI
Installation instructions
Package contents
■ User interface
■ 2 screws and 2 plastic dowels
■ End-user manual
Installation precautions
Introduction
Read the instructions carefully before
placing this device. The manufacturer
declines all responsibility for any
inconveniences or damages caused by not
complying with instructions given in this
manual. All warranty claims are void if
instructions provided in this manual are
not observed.
■ Onlyqualiedinstallersshouldbe
allowed to install and service the
equipment.
■ All instructions provided in this
manual should be read and followed.
■ Incoming equipment should be
carefully checked for possible damage
caused during transport or by incorrect
handling.Incaseofdamage,lea
claim with the transport company.
General installation requirements
■ After the installation, carry out a
complete system check and explain all
system functions to the user.
■ Dispose of all packaging materials in
accordance with all applicable local
regulations.
Protection against electrocution
Take precautions to prevent electrostatic
discharge to the device when installing,
servicing or operating the equipment.
Environmental
Storage temperature: -20 to 50°C
Relative humidity: 0 to 95% non-condensing
Operating temperature: 5 to 40°C
WTC-RCI-D
WTC-RCI-DC
WTC-RCI-DM
WTC-RCI-DCM
English

Carrier WTC-RCI Specifications

General

Brand	Carrier
Model	WTC-RCI
Category	Controller
Language	English

Summary

Installation Precautions

Introduction

Details regarding careful reading of instructions, installer qualifications, and checking for transport damage.

General Installation Requirements

Complete system check after installation and proper disposal of packaging materials according to local regulations.

Protection Against Electrocution

Take precautions to prevent electrostatic discharge to the device when installing, servicing, or operating.

Environmental Considerations

Specifies storage temperature (-20 to 50°C), relative humidity (0-95% non-condensing), and operating temperature (5-40°C).

Overview of Room Control Interface

General Description

Provides precise local temperature sensing, system status display, and control functions for room occupants.

Device Dimensions

Motion Detection Pattern

Illustrates horizontal and vertical detection angles for the motion sensor.

Mounting Instructions

General Recommendations

Advises on optimal placement, avoiding heat sources, air discharges, direct sun, and ensuring proper ventilation.

Maintenance

The Room Control Interface requires no special maintenance; clean with a soft dry cloth.

Installation Procedure

Step-by-step guide for mounting the device on a dry wall using supplied screws and anchors.

Connector and Jumpers

Jumper Configurations

Details configurable jumpers for PIR LED, Subnetwork End of Line, and Local Area Network type.

Connection Cable

RJ45 Terminations

Explains T568A and T568B wire sequence for RJ45 connectors used with Cat5e Ethernet patch cables.

Configuration

System Settings

Allows users to set various control parameters like password, contrast, display options, and setpoints.

Modifying System Settings

Step-by-step guide to access and modify system settings, including password entry and navigation.

Example: Adjusting Display Contrast

Illustrates the process of navigating to the contrast menu and adjusting the screen contrast ratio.

System Settings Overview