37
No. 1 0300 3
09/ 06
2WD Buggy DAZZLER
RC-system
Transmitter does not work pro-
perly
Transmitter and/or receiver batteries are
empty
Replace the transmitter and/or the receiver
batteries
Batteries are inserted wrong Test the polarity of the batteries
Plug from the receiver battery is loose Plug-in the plug firmly
Poor reception Receiver antenna is not pulled out completely
Transmitter range is too small Transmitter and/or receiver batteries are too
weak
Replace the transmitter and/or the receiver
batteries
Transmitter antenna is not pulled out
completely
Pull out the antenna completely
Receiver antenna is not pulled out completely Pull out the antenna completely
Receiver antenna is cut Let repair the receiver antenna
Servos do not work properly Transmitter and/or receiver batteries are too
weak
Replace the transmitter and/or receiver batteries
Gear wheels inside the servo gear do not
engage or are defective
Let repair the servo
Adjusting ring at the steering levers are loose Fix the adjusting rings again, use the standard
settings
RC transmitter does not work well
while the engine is running
Receiver crystal is loose Put-in the receiver crystal again
Plug from the receiver batteries is loose Plug-in the plug again
Poor reception Receiver antenna is not pulled out completely
Receiver damaged, e.g. after a crash Repair the receiver
Chassis
Model pulls to one side Steering trim is misaligned Correct the neutral position on the remote control
Alignment right and left is different
Reset the alignment on both sides to 0
degrees.
Wheel damaged on one side or bearings
defective
Remove the wheel, clean the bearings and, if
necessary, replace
Model can be controlled but only
with difficulty
Servo links not properly adjusted Place servos in neutral position and readjust
Receiving power of the antenna is too small Pull out the antenna of the transmitter completely.
Completely unwind the antenna of the receiver
and guide it upwards
Batteries of transmitter and/or receiver empty Replace batteries or recharge rechargeable bat-
teries
Poor braking Brake linkage misaligned Correct the adjustment of the brake steering lever
Brake disc worn out Replace brake disk
Clutch does not engage Clutch shoes worn out or defective Replace clutch shoes
Clutch bell worn out or defective Replace clutch bell
Fly wheel is loose Retighten fly wheel.
Clutch does not disengage Spring for clutch shoes worn out or defective Replace springs
Model does not function Main pinion defective Replace main pinion
Damaged pinions in the differential Replace pinions
Centrifugal clutch set too loose Reset centrifugal clutch
Damping not functioning One or more dampers are jammed Clean and/or disassemble dampers
Piston rod bent Repair the piston rod
Shock absorbers lose oil A damping component is defective Check and replace the corresponding part
Sealings worn out Replace sealings
Model rolls over towards the back
during acceleration
Centrifugal clutch set too taut Loosen the adjusting screw until the model runs
smoothly
To Next Page
Loading...
