CAS CUW Series - Delimiter; Decimal Point Symbol in Output Data

101
15.3.7 Delimiter
The “delimiter” is used to separate individual pieces of data or commands. Set the delimiter
as follows:
Set to CR(0DH): Select menu item 94.
Set to LF(0AH): Select menu item 95.
Set to CR+LF(0D0AH): Select menu item 96.
WindowsDirect setting (down) :
equivalent to pressing the Enter key of the computer after typing the value:
Select menu item 97.
WindowsDirect setting (right) :
equivalent to pressing the right arrow key of the computer after typing the value:
Select menu item 98.
Settings for “WindowsDirect” (menu items 97 and 98 )
When these menu items are selected, it is not possible to send commands to the balance
from the peripheral instruments.
15.4 Decimal Point Symbol in Output Data
The decimal point symbols in the outputted data to external devices can be selected from “.”
(period) or“,” (comma) depending on your preference. Note that the decimal point
expression on the balance display is always with “.” (period).
To select “.” as outputted decimal point, select menu item number 72a. “dECP-Pr”
To select “,” as outputted decimal point, select menu item number 72b. “dECP-Cn”
The setting made here in “Decimal Point Symbol in Output Data” will not be cleared
with Menu reset (See 7.5.2).