71
13.6 Taring/Printing at Stability
Determine if the balance should wait for stability before printing when the [PRINT] key
is pressed or zeroing when the [O/T] key is pressed.
To print or tare without waiting for stability: (Immediately operating mode)
Select menu item 39 .
To have printing or taring take place after stability is detected: (Waiting for stability
detection)
Select menu item 40 .
x While the balance is waiting for stabilization, ---- is displayed.
x When the [O/T] key has been pressed,
“---” is displayed. At this occasion, press the [POWER] key if you desire
to disable this function and abort taring.
x When the [PRINT] key has been pressed,
Once the communication symbol and the Stand-by symbol are lit, then stability
detection is waited. The data will be output after stability is detected. If the [POWER]
key is pressed during the waiting, the balance is brought to stand-by. The data will be
printed upon stability in the next weighing.
x See 13.5 for details of Zero Range.
x See 11.3 for details of stability detection.
To Next Page
Loading...
