CAS DL-150 Owner's Manual

11
10
kg
kg
2. Weighing with Tare
TARE means the weight of container being used for a commodity.
TARE key function is to subtract the weight of the container from full weight
loaded.
4. HOLD Function
When the weight is not stable, press the MODE key.
The display shows the “HOLd” and then press ZERO key.
The display will show average weight.
Place a container on the
platter.
Press the TARE key.
Remove container and
commodity, then the display
will show the weight of the
container with "-" symbol.
Press the TARE key, then
display will show the
"0.00".
Place a commodity into the
container, then the display
will show only the weight of
the commodity.
kg
kg
kg
kg
kg
When the weight is unstable,
pres the MODE key.
The display shows the "HOLd".
Press ZERO key. Then "HOLd"
display blink for two times.
Then the display will show
the averageweight.
The average weight
blink for two times.
*NOTE : Stable indication(0) will not display in HOLD mode.
kg
Remove the commodity from
the platter.
3. Changing Unit of Weight
(kg, lb, oz)
Press the MODE key first. Holding it, press the TARE key in the simple
weighing mode. The display shows the "UnIt" shortly and then you may select
kg, lb, or oz as the unit of weight.
Press ZERO key once to set
up the low limit. The display
shows "0.00" and the first
number flashes.
Press the MODE key until
the display shows "WL
OFF". "WL OFF" means
that comparator function
is not activated.
Press TARE key to activate
this function. The display
shows "WL ON".
5. Comparator Function - HI / LOW Limit Setting

CAS DL-150 Specifications

General

Brand	CAS
Model	DL-150
Category	Scales
Language	English