15
14
7. Auto Power Off Function
Auto-Power off function is to automatically power off as time is set. This
function is helpful to save battery, which is not in use. The following is the
setting procedure of Auto-power off.
When the scale is turned off
press ON/OFF key, holding
ZERO key. Then you will see
the "AP-10".(If you have set
this before,display will show
previous value.)
Press the TARE key until the
display shows the "AP-x0"
that you wish to take.
(Refer to TABLE 1.)
Press the ON/OFF key, and
then the scale saves what you
programmed and shows all
the segments, counting up
"0" to "9".
DISPLAY FUNCTION
AP-00 This function does not automatically power off.
AP-10 This function does automatically power off when the scale is not in use for 10 minutes.
AP-20 This function does automatically power off when the scale is not in use for 20 minutes.
AP-30 This function does automatically power off when the scale is not in use for 30 minutes.
TABLE 1.
Put all of commodities you
wish to count, and then
count the number on display.
Remove all of commodities
from the scale.
Remove all of commodities
from the scale.
Remove the tare from
the platter.
Counting with Tare
Press MODE key twice to go to
sample unit selection mode.
"PCS" is shown on the display,
then press ZERO key to select
the number of sample unit.
Put the container on the
scale and press TARE key to
set weight of tare.You can
select 10, 20, 30, 40, 50,
60, 70, 80, 90, 100,200,
300,400, or 500 as a sample
unit, by pressing ZERO key.
If the number of selected
sample unit is 20, please
put 20 sample units on the
scale.Then press TARE key
to set unit weight.
When you try to set the number
of sample unit at the stage the
display may show "LACK"
message shortly.
The result of counting may be
incorrect in the following cases.
a.unit weight 1/2
e *
b.
weight loaded 2% of maximum
weighing capacity.
Press "Zero" key and then press
"Tare" key to exit from
tare function.
*"e" value may be various on capacity of product model.
Please refer to "SPECIFICATION" on page 18. For example, a product model
which capacity is 60.00kg has 0.02kg as "e" value