9
8
Make sure that power is OFF. While pressing "#" key,
turn on the power. “EcrSEt” is shown on the disply. And then
current ECR type is shown on the display as “tYPE-2”.
2
.
ECR Interface
PD-II can interface with most ECRs by selecting TYPE 0 to TYPE 6.
ECR Type Selection
OPERATIONS
1
.
General Weighing
The display indicates ZERO symbol, if weight is at ZERO.
When the display is not zero though there is nothing on the platter, press the
ZERO key.
Turn on the power. The display shows 0.00 or 0.000.
Make sure that ST(Stable) and ZERO lamps are On.
Place an item on the platter. When the ST(Stable) lamp is
0n, read the weight.
KEY FUNCTIONS
Used to set the zero point to 0.00 or 0.000.
Used as ESC key in Setup Mode.
Used as ENTER key in Setup Mode.
Used as Scroll key in Setup Mode.
KEY DESCRIPTION
If you select ECR type 5, press the " " key until the display
shows “tYPE-5”. (Refer to Table 1.)
To save current ECR type, press the ZERO key.
To Next Page
Loading...
