3
Table: Error Messages
Error Message
on Display
Description Solution
“Err 0” The “Err 0” occurs when scale is not stable. Remove unstable facts.
“Err 1”
The “Err 1” occurs when a current zero
point
has shifted from the last span calibration.
Please call your CAS dealer.
“Err 3” The “Err 3” is an overload error. Please remove the weight.
“Err 4” The “Err 4” is short of payment. Scale needs more payment.
“Err 5” The “Err 5” means there is already tare. Remove the tare.
“Err 6”
The “Err 6” means total price summation
is over.
Please change unit price or
remove some weight.
“Err 8” The “Err 8” means Euro rating price is over.
Please change unit price or
change euro rate.
“Err13”
The “Err13” means the soft key code is
broken
Please try to find out which
key lost soft key code and
then input this code again.
"Err 15"
The "Err 15" means 1/2 or 1/4 unit price is
over.
Please change unit price
Diagram : Serial Interface
To Next Page
Loading...
Need help?
General
