Cascade J Series - Page 12

6871082-R210
INSTALLATION
CC0201.eps
Sideshift Relief Adjustment (Internal SS only)
A Clamp a maximum load and sideshift LEFT and RIGHT
observing sideshifting movement.
B If the attachment will not sideshift or sideshifts slowly,
adjust SIDESHIFT relief clockwise (CW) until the
attachment sideshifts. Then, adjust the relief cartridge
counterclockwise (CCW) in 1/4 turn increments until
sideshift speed slows (relief opening). Finish by
adjusting cartridge clockwise (CW) 1/4 turn. Tighten
jam nut.
D
B
Increase
(CW)
Decrease
(CCW)
RH CLAMP PortsLH CLAMP Ports
Adjust Relief Cartridges (continued)
Clamp Relief Adjustment – Clamp Force Method
A Cascade 4-Point Force Distribution Tester is required for
this procedure.
A Extend the arms to the most common load width.
Lower the contact pads to just above the floor.
B Position the tester between the contact pads. Adjust
the tester's spindle locations to be perpendicular to
the contact pad surfaces and to the desired position
based on the type of product being handled.
C Set the truck CLAMP circuit to the approximate
pressure for the required clamp force on the load.
D Clamp on the tester and hold activated for 5 seconds.
E The tester will display clamp force and percentage of
clamp force for each spindle location and total clamp
force (sum of force of the four spindles).
F Adjust the truck CLAMP circuit pressure to the required
total clamp force for the load.
AC2961.eps
Sideshift
Relief
Cartridge
Sideshift
Relief
Cartridge
SIDESHIFT
Supply
SIDESHIFT
Supply
CLAMP
Supply
CLAMP
Supply