Cascade J Series - Page 7

6871082-R2 5
INSTALLATION
GA0092.eps
Flush hydraulic supply hoses
A Install hoses using union fittings.
B Operate auxiliary valves for 30 seconds.
C Remove union fittings.
4
CL2787.eps
CL0242.eps
CL5656.eps
5
Mount attachment on truck carriage
A Center truck behind the attachment.
B Tilt forward and raise carriage into position.
C Engage upper mounting hooks with upper
carriage bar. Make sure a centering tab or
hook tab engages a notch on the carriage bar.
Refer to the illustration below.
D Lift the attachment 2 in. (5 cm) above pallet.
ITA Class II – 0.60–0.66 in. (15–17 mm)
ITA Class III – 0.72–0.78 in. (18–20 mm)
Truck
Carriage
Engage
Notch
ITA Class II – 0.32–0.36 in. (8–9 mm)
ITA Class III – 0.39–0.43 in. (10–11 mm)
Centering TabsLeft Hook Tab
External
Sideshifter
A
B
Side View
(Standard Carton Clamp Shown)
Back (Driver's) View
(Standard Carton Clamp Shown)