30
Draft Control
Step 1: draft control wheel fully to the left,
then let the implement penetrate the soil.
Step 2: start working with the correct
working depth.
Step 3: Set the draft control dial so the
implement is reacting to the draft force.
This is shown on the control panel via
control lamps Æ both are blinking together.
Note: turning the draft control knob
clockwise lets the draft load sensing pins
react quicker to draft load variations
(increased sensibility).
Step 4: The lower limit setting (position
control dial) will stop the implement
lowering past this point regardless of draft
force.
Step 5: Adjust the draft response control.
1
2
4
5
3
Follow the steps,
look at the
arrows direction!
To Next Page
Loading...