SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï77
When the optional electronic bale length or moisture kit
is installed a bale icon (1) is shown in the menu bar.
Then by using the soft key, encoder, or touch screen
the bale can be highlighted and selected to enter the
field setting screen.
NOTE: If the electronic bale length and moisture kit is not
installed then this icon does not appear.
Electrical Bale length
In the field setting screen and by using the soft key,
encoder, or touch screen the bale length (1) can be
highlighted and changed by the customer. Use the
second field (2) to enter real bale length in order to
calibrate.
• PRESET BALE LENGTH in metres
This is only possible if bale length is installed
• BALE LENGTH CALIBRATION in metres
Minimum 0.5 m (1.6 ft)
Maximum 2.4 m (8.0 ft)
With the required field highlighted press enter to obtain the
numeric keypad.
Then use soft keys or rotary encoder to select a bale length.
Moisture
In the field setting screen and by using the soft key,
encoder, or touch screen the moisture warning can
be highlighted and changed.
Adjustments are then made by the operator to warn when
required low or high readings are exceeded.
To Next Page
Loading...