ELECTROMAGNETIC COMPATIBILITY (EMC)
Disturbances remain possible if added equipment
does not meet the standards. As these interference's
may result in serious malfunction of the machine
and/or create unsafe situations the following
instructions must be observed:
The maximum power of emission equipment (radio,
telephones, etc.) must not exceed the limits imposed
by the national authorities of the country of usage of
the machine.
The electromagnetic field generated by the added
system must not exceed 24 V/m at any moment and
at any location in the proximity of electronic
components and the network between them over the
entire machine.
VIBRATION LEVEL INFORMATION
The vibration level for the arms to which the operator
of this machine is exposed under normal operating
conditions is below the 2.5 m/sec
2
weighted root
mean square (RMS) value. The vibration level for the
whole body is below the 0.5 m/sec
2
RMS value.
LEGAL OBLIGATIONS
Your machine may be equipped with special guarding
or other devices in compliance with local legislation.
Some of these require active use by the operator.
Therefore, check local legislation on the usage of this
machine.
SAFETY REQUIREMENTS FOR FLUID POWER
SYSTEMS AND COMPONENTS
European standard EN 982
Flexible hose assemblies must not be constructed
from hoses which have been previously used as part
of a hose assembly.
Do not weld hydraulic piping.
When flexible hoses or piping are damaged, replace
them immediately, using genuine service parts.
It is forbidden to modify a hydraulic accumulator by
machining, welding or any other means.
Before removing hydraulic accumulators for
servicing, the liquid pressure in the accumulator must
be reduced to zero.
Pressure check on hydraulic accumulators shall be
carried out by method recommended by the
accumulator manufacturer.
Care must be taken not to exceed the maximum
allowable pressure of the accumulator. After any
check of adjustment there must be no leakage of gas.
PRECAUTIONARY STATEMENTS
Personal safety
Throughout this manual and on machine decals, you
will find precautionary statements (”CAUTION”,
”WARNING”, AND ”DANGER”) followed by specific
instructions. These precautions are intended for the
personal safety of you and those working with you.
Please take the time to read them.
CAUTION
The word ”CAUTION” is used where a safe behavioural
practice according to operating and maintenance
instructions and common safety practices will protect the
operator and others from accident involvement.
The word ”WARNING” denotes a potential or hidden
hazard which could possibly cause serious injury. It is used
to warn operators and others to exercise due care and
attention to avoid a surprise accident with machinery
The word ”DANGER” denotes a forbidden practice in
connection with a serious hazard, that could result in
death.
FAILURE TO FOLLOW THE ”CAUTION”,
”WARNING”, AND ”DANGER” INSTRUCTIONS MAY
RESULT IN SERIOUS BODILY INJURY OR DEATH.
To Next Page
Loading...