SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï10
Adjust the tow hitch to the following dimensions for all
baler hitches in the high position:
X3 180 mm (7 1/16 in)
Y3 200 mm (7 7/8 in)
Y4 750 to 1000 mm (29 1/2 in to 39 3/8 in)
CAUTION
The hydraulic lift arms of the tractor must be removed
TRACTOR WHEEL SETTING
As the tractor has to straddle the windrow, ensure the
tractor selected has adequate clearance under the
tractor frame to avoid bunching of the material. If
required, attach a canvas under the tractor body, rear
axle and hitch to deflect the crop down.
PTO SHAFT
The baler is equipped with a PTO shaft with front yoke
for attaching to a
• 6 splines, 1-3/8 in PTO shaft or
• 21 splines, 1-3/8 in PTO shaft or
• 20 splines, 1-3/4 in PTO shaft
All PTO shafts are designed to operate at 1000 rpm
To Next Page
Loading...