SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï106
Moisture too low (where fitted)
When the moisture is too low below the predefined
level set by the operator (Minimum 9%) the warning
will be displayed on the screen.
The operator then must make the decision to accept
this level or to stop baling.
Moisture too high (where fitted)
When the moisture is too high above the predefined
level set by the operator (Maximum 60%) the warning
will be displayed on the screen.
The operator then must make the decision to accept
this level or to stop baling.
226
To Next Page
Loading...