SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï109
This alarm message will appear in case the knotter drive
PTO shearbolt fails.
Press the escape key to stop the audible alarm.
STOP messages remain on the screen until after
replacement of the shearbolt and the machine is
restarted and running above (>600 rpm).
Refer to Section 4-36
Feeder
This alarm message will appear when a feeder shearbolt fails.
Shut down the PTO immediately.
Press the escape key to stop the audible alarm.
The message remains on the screen until after
replacement of the shearbolt and the machine is
restarted and running above (>600 rpm).
Pick-up blocked
This alarm message will appear as soon as the pick‐
up speed drops too much below the normal operating
speed.
Press the escape key to stop the audible alarm.
The message remains on the screen until the problem is
solved.
Mistie
This alarm message will appear in case more than one
knotter is not performing properly.
Press the escape key to stop the audible alarm.
The message remains on the screen until thread movement is
detected or the sensors are adjusted.
NOTE: Refer to 4-57 Mistie adjustments.
To Next Page
Loading...