Case 446 - Detailed Lubrication Chart

/
SERVICE POINTS
Front Spindles (king pins) I 2 Iff::
CD
HOURS
5 OR
DAILY
•
HOURS
OR
WEEKLY
HOURS
B
•
OR
YEAF(LY
2
3
4
6
7
8
9
10
11
12
13
17
18
19
20
21
22
:::::::::::
::::::::
~:~:~:~:~:
;;;:;:;:::
I? ~;::::::'
1:;; ;; ;;;;
f;;::;::;::
:=:= :::: ::'
::::::::::
. .. .......
:.:.:.:.:.
::::; : :::::
::~:~:~:~:
::~:~:~:~:
::::::::::
:;: ;:;:;:::
• Keep oil level between marks on dipstick. See page 14 for engine lubrication
recommendations. Capacity 4 pts. (1 .9 I)
•• Be sure there are no leaks between gaskets, joints at carburetor, air cleaner and
cylinder block .
• • • More
often in dusty conditions .
°Clean and regap
+Hydraulic System: Use SAE 5W·20 motor oil in winter (below 32
0
F (O°C)). Use
SAE 20W-40 motor oil in summer. Use API Service Classi-fication SE or CC motor
oil. The hydraulic reservoir filler cap is located just to the left of the battery. The
oil level
must be maintained at 5" to 6" (120 mm to 150 mm) down from the fil-
ler. Overfilling will result in oil leakage from the fill cap, underfilling will result in
erratic operation. The oil drain plug is a 1/4" allen plug on the underside of the
travel valve
inlet port.
Transmission: Use SAE 20-W-40 motor oil or SAE 80 EP gear lube in the transmis-
sion the
year round .
Grease Fittings : Use number 1 gun grease (Lithium Base) for all pressure fittings (as
many strokes as required).
- 9 -