To Next Page
P
pcruzSep 9, 2025
What to do if injection pump controls are broken in Case Engine?
- AAmber HallSep 9, 2025
If the injection pump controls are broken in your Case Engine, replace the faulty parts.
What to do if injection pump controls are broken in Case Engine?
If the injection pump controls are broken in your Case Engine, replace the faulty parts.
How to fix water pump drive belt slack in Case Engine?
If the water pump drive belt is slack in your Case Engine, check and adjust the tightness of the belt.
How to fix a flat or faulty Case 668T/M2 Engine battery?
If the Case Engine battery is flat, check and recharge it. If the battery is faulty, replace it.
How to remove air from fuel and injection system in Case Engine?
If there is air in the fuel and injection system of your Case Engine, check that the hoses are not cracked or the unions loose. Replace worn parts, remove the air from the hoses and deaerate the injection pump and fuel filter by unscrewing the caps and working the primer pump by hand.
How to remove impurities or water from Case Engine fuel lines?
If there are impurities or water in the fuel lines of your Case Engine, disconnect the hoses and clean them using a jet of compressed air. Dismantle and clean the injection pump. Remove water from the tank and refuel.
How to fix incorrect timing of injection pump in Case 668T/M2 Engine?
If the timing of the injection pump is incorrect in your Case Engine, check and correctly time the injection pump.
How to remove air bubbles from Case 668T/M2 Engine fuel lines?
If there are air bubbles in the fuel lines or injection pump of your Case Engine, check the hoses to ensure that air is present and also check the fuel pump. Eliminate the air from the injection pump by unscrewing the cap and working the fuel pump by hand.
How to replace a malfunctioning thermostat in Case 668T/M2?
If the thermostat is malfunctioning in your Case Engine, replace it.
How to increase coolant level in Case 668T/M2 Engine?
If the coolant level is too low in your Case Engine, top up the radiator with coolant.
How to repair a faulty starter motor in Case 668T/M2?
If the starter motor in your Case Engine is faulty, repair or replace it.
Description and layout of the engine lubrication system for 4-cylinder engines.
Description and layout of the engine cooling system for 4-cylinder engines.
Diagram and description of the turbocharger system and its components.
Details on the mechanical components of the engine, covering overhaul procedures.
Guidance on diagnosing and resolving engine issues.
Planning of controls and periodic interventions for engine maintenance.
Detailed clearance data for cylinder unit and crankshaft components for 4 and 6 cylinder engines.
General instructions for engine overhaul procedures.
Detailed repair operations for the cylinder unit, including checks and measurements.
Procedures for measuring journals and crankpins, and checking clearances.
Data and assembly procedures for connecting rods, pistons, pins, and bearings.
Procedures for removing valves, checking seals, and supporting surfaces.
Data and checks for intake and exhaust valves, including carbon deposit removal and grinding.
Steps for fitting the cylinder head, including lubrication and sealing rings.
Specific torque values for various screws used in cylinder head and connecting rod assembly.
General