www.casellasolutions.com
Configure the dBadge2
You will typically not need to do this every time the dBadge2 is used.
Press the left hand key to power up the dBadge2, release the key
then immediately press both keys to enter the configuration mode.
This allows the following settings to be made:-
Select language
Adjust date and time
Set the display contrast
Set the display timeout interval
Specify the dosimeter setup to be displayed for D1 and optionally
D2 and D3
Select/deselect the capture of Audio Notes (Pro & Plus)
Select/deselect real-time octave band analysis (Pro)
Select/deselect the availability of ‘Pause’ function
Select/deselect events & audio capture (Plus & Pro)
Select/deselect the visual alarms feature
Select/deselect Auto Lock of the keys
Select large or small display font
Select/deselect Auto Scroll of the display
Select/deselect the Timer mode (Off, fixed run duration, or
delayed start)
Select/deselect Bluetooth connectivity (see note below)*
Clear the memory
Cycle back through the configuration menu or exit
Note: For use in Radio or Security sensitive locations (i.e. Hospitals, Aviation, etc.),
Bluetooth® connectivity may be fully disabled by using the firmware upgrade utility. When
disabled, the Bluetooth menu option will not be shown in the settings menu.
Generally, pressing the left hand key scrolls through the available
options for each setting and the right hand key accepts the change
To Next Page
Loading...
Need help?
General
