EN-27
Signal Reception Troubleshooting
Check the following points whenever you experience problems with calibration signal
reception.
Problem Probable Cause What you should do
Cannot perform
manual receive.
• The watch is not in the Timekeeping Mode.
• Your current Home City is not one of the
following city codes:
HNL, ANC, YVR, LAX, YEA, DEN, MEX,
YWG, CHI, MIA, YTO, NYC, YHZ, YYT,
LIS, LON, MAD, PAR, ROM, BER, STO,
ATH, MOW, HKG, BJS, TPE, SEL, and
TYO.
• The countdown timer is running.
• Enter the Timekeeping
Mode and try again (page
EN-24).
• Select one of the cities to
the left as your Home City
(page EN-10).
• Stop the countdown timer
(page EN-32) and try again.
Auto receive is
turned on, but the
Level 3 receiving
indicator does
not appear on the
display.
• You changed the time setting manually.
• The watch was not in the Timekeeping or
World Time Mode, or you performed some
button operation during the auto receive
operation.
• Perform manual signal
receive or wait until the
next auto signal receive
operation is performed.
To Next Page
Loading...
Need help?
General
