EN-28
Problem Probable Cause What you should do
Auto receive is
turned on, but the
Level 3 receiving
indicator does
not appear on the
display.
• Even if receive is successful, the Level 3
receiving indicator disappears every day
when the first auto receive operation of
the day is performed.
• Time data (hour, minutes, seconds) only
was received during the last receive
operation. The Level 3 receiving indicator
appears only when time data and date
data (year, month, day) are both received.
• Perform manual signal
receive or wait until the
next auto signal receive
operation is performed.
• Check to make sure the
watch is in a location
where it can receive the
signal (page EN-14).
Time setting
is incorrect
following signal
reception.
• If the time is one hour off, the DST setting
may be incorrect.
• The Home City code setting is not correct
for the area where you are using the
watch.
• Change the DST setting to
Auto DST (page EN-46).
• Select the correct Home
City code (page EN-10).
• For further information, see “Important!” (page EN-14) and “Radio-controlled Atomic
Timekeeping Precautions” (page EN-50).
To Next Page
Loading...
Need help?
General
