E-31
Probable Cause
• You changed the time setting
manually.
• You performed some button
operation during the auto receive
operation.
• The watch is not in the
Timekeeping Mode.
• Signal reception results are reset
when the first auto receive
operation is performed on the
following day.
• Radio interference is often present
during the day time, which can
interfere with calibration signal
reception.
Problem
The second
hand is pointing
at NO (N).
What you should do
•
Perform manual signal
receive at night or wait until
the next auto signal receive
operation is performed.
•
Enter the Timekeeping
Mode and try again.
• Check to make sure the
watch is in a location
where it can receive the
signal (page E-23).
Signal Reception Troubleshooting
Check the following points whenever you experience problems with signal reception.
To Next Page
Loading...
