Casio 5618 User Manual

Lap Times
A lap time is the time elapsed during a specific
lap or segment. Lap times are recorded
internally by the watch. The watch displays the
elapsed time of the current lap.
D
Start
B
Lap 1
B
D
Goal
Lap 2
Lap 3
Note
●
Lap times can be viewed with EDIFICE
Connected after measurement is
complete.
l
Viewing Stopwatch Data
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper will not sound if battery power
is low.
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (B) for at least two seconds.
Release the button when the hour digits
start to flash.
Hours
3. Use (A) and (D) to change the timer hours
setting.
4. Press (C).
This causes the minutes digits to flash.
Minutes
5. Use (A) and (D) to change the timer
minutes setting.
6. Press (C).
This causes the seconds digits to flash.
Seconds
7. Use (A) and (D) to change the timer
seconds setting.
8. Press (B) to exit the setting screen.
Note
●
You can also use EDIFICE Connected
to configure timer settings.
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
To reset a paused countdown to the
start time, press (B).
3. Press any button to stop the tone.
Alarms and Hourly Time
Signal
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The beeper will not sound if battery power
is low.
Operation Guide 5618
11

Casio 5618 Specifications

General

Brand	Casio
Model	5618
Category	Watch
Language	English