Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Press (C) 12 times.
This causes [KEY♪] or [MUTE] to flash on
the display.
4. Use (D) to select [KEY♪] or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
5. Press (B) to exit the setting screen.
Note
●
Note that alarm and timer tones will still
sound even while the operation tone is
muted.
Returning the Watch to Its
Factory Default Settings
This section explains how to return the watch
settings below to their initial factory defaults.
●
Watch Settings
●
Stopwatch
●
Timer
●
Alarm
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Press (C) three times.
This causes the seconds to flash.
4. Hold down (A) for at least five seconds.
Release the button when [RESET] stops
flashing.
Note
●
Resetting the watch will also delete
information for pairing the watch with a
phone, and unpair them.
Moving to Another Time
Zone
When you enter another time zone, the watch
will adjust its time setting to your current
location in accordance with the time zone of
your phone. When you reach your destination,
disable the watch Airplane Mode.
1. When you reach your destination,
establish a connection between the watch
and your phone.
l
Using the Watch in a Medical Facility or
Aircraft
After you disable the watch’s Airplane
Mode, it will adjust its time setting to the
time in your current location.
●
If you want to trigger immediate time
adjustment, refer to the information at
the link below.
l
Triggering Immediate Time
Adjustment
Operation Guide 5618
15
To Next Page
Loading...
Need help?
General
