Stopwatch
The stopwatch measures elapsed time in units
of one second up to 23 hours, 59 minutes, 59
seconds (24 hours).
Measuring Elapsed Time
30
Seconds
Minutes
Hours (24-hour time)
Hours
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
3. Press (D) to reset the stopwatch to all
zeros.
●
Pulling out the crown while an elapsed
time measurement operation is in
progress will reset the displayed value
to all zeros.
Measuring a Split Time
30
Seconds
Minutes
Hours (24-hour time)
Hours
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
●
Each press of (D) causes the elapsed
time up to that point (split time) to be
indicated for about five seconds.
3. Press (D) to reset the stopwatch to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use CASIO WATCHES to set the timer
start time.
l
Configuring Watch Settings
Watch Operation Guide 5672
24