●
Stopwatch Mode
The second hand, and the small hour and
minute hands indicate the elapsed stopwatch
time.
●
The main hour and minute hands indicate
the current time.
A Stopwatch seconds
B Stopwatch hours (24-hour time)
The hand points to the A-side for hours 0
through 12, and to the P-side for hours 12
through 24.
C Stopwatch hours
D Stopwatch minutes
●
Timer Mode
The second hand, and the small hour and
minute hands indicate the current countdown
time.
●
The main hour and minute hands indicate
the current time.
A Timer seconds
B Timer hours (24-hour time)
The hand points to the A-side for hours 0
through 12, and to the P-side for hours 12
through 24.
C Timer hours
D Timer minutes
●
Alarm Mode
The small hour and minute hands indicate the
alarm time.
The second hand indicates the alarm enabled/
disabled setting.
●
The main hour and minute hands indicate
the current time.
30
②④③
①
Enabling/
Disabling the
Alarm
A Alarm enabled/disabled
B Alarm hour (24-hour time)
The hand points to the A-side for a.m.
times, and to the P-side for p.m. times.
C Alarm hour
D Alarm minute
Using the Crown
The watch’s crown is a screw-in (screw lock)
type. To use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be sure
to screw the crown in by rotating it
away from you as you push it in.
●
When pushing the crown back in, take
care not to apply too much force.
●
Fast Forward/Fast Reverse
Second click
First click
Normal timekeeping
Crown
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Watch Operation Guide 5672
8
To Next Page
Loading...
Need help?
General
