●
Switching between 12-hour and 24-
hour Timekeeping
You can specify either 12-hour format or 24-
hour format for the time display.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (C) eight times.
This causes [12H] or [24H] to flash on the
display.
4. Press (D) to toggle the setting between
[12H] (12-hour timekeeping) and [24H]
(24-hour timekeeping).
24-hour
timekeeping
12-hour
timekeeping
5. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where connection with
a phone may cause problems, you can
perform the procedure below to disable auto
time correction. To re-enable auto time
correction, perform the same operation again.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (C) 13 times.
This displays [RCVD].
4. Press (D) to change the auto time
correction settings.
[OFF]: Auto time correction disabled.
[ON]: Auto time correction enabled.
5. Press (A) to complete the setting
operation.
Note
●
The auto time correction setting can be
changed only while the watch is paired
with a phone.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
World Time
World Time lets you look up the current time
in any one of 38 cities around the globe, and
UTC (Coordinated Universal Time).
Using CASIO WATCHES to
Configure World Time City
Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set the World Time city.
l
Configuring World Time Settings
Note
●
World Time cities that can be selected
only by using the CASIO WATCHES
phone app cannot be selected using
watch operations.
Checking World Time
1. Enter the World Time Mode.
l
Navigating Between Modes
After the currently selected World Time
City name appears, the watch will display
the current time in that city.
●
You can display the World Time City
while in the World Time Mode by
pressing (A).
World Time
World Time City
Watch Operation Guide 5729
17
To Next Page
Loading...
