Casio 5729 - Timer; Using CASIO WATCHES to Configure Timer Settings; Setting the Countdown Start Time; Using the Timer

Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set the timer start time.
l
Configuring Watch Settings
Setting the Countdown Start
Time
The start time can be set in 1-second units up
to 60 minutes.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the minutes
setting starts to flash.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
Minutes
3. Use (B) and (D) to change the minutes
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4. Press (C).
This causes the seconds digits to flash.
Seconds
5. Use (B) and (D) to change the seconds
setting.
6. Press (A) to exit the setting screen.
Note
●
Setting a start time of [00’00] will
perform a countdown of 60 minutes.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
Minutes, seconds
2. Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (A).
3. Press any button to stop the tone.
Watch Operation Guide 5729
22