Measuring Elapsed Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
●
Elapsed time is shown in 1/100-second
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
1/100 seconds
Seconds
Minutes, seconds Hours, minutes
After first hourFirst hour
3. Press (A) to reset the measurement time
to all zeros.
Measuring a Split Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
●
If a stopwatch timing operation is in
progress, press (D) to stop it and then
press (A) to reset the stopwatch to all
zeros before performing the operation
in step 2.
2. Press (A) to display [SPL].
3. Use the operations below to measure
elapsed time.
●
Pressing (A) displays the elapsed time
up to that point (split time), alternating
with [SPL] for about eight seconds.
●
Elapsed time is shown in 1/100-second
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
1/100 seconds
Seconds
Minutes, seconds Hours, minutes
After first hourFirst hour
4. Press (A) to reset the measurement time
to all zeros.
Measuring Lap Times
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
●
If a stopwatch timing operation is in
progress, press (D) to stop it and then
press (A) to reset the stopwatch to all
zeros before performing the operation
in step 2.
2. Press (A) to display [LAP].
3. Use the operations below to measure
elapsed time.
●
Each time you press (A), the watch
displays the time elapsed (lap time)
since the last lap time operation,
alternating with the lap number for about
eight seconds.
●
Elapsed lap time is displayed in 1/100-
second units for the first hour. After that,
it is displayed in one-second units.
1/100 seconds
Seconds
Minutes, seconds Hours, minutes
After first hourFirst hour
4. Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 5729
21
To Next Page
Loading...
