Auto Time Correction by
Bluetooth Connection (Time
Correction)
Q1
When does the watch correct its
time?
The watch will connect with the phone and
perform auto time correction at around 12:30
a.m., 6:30 a.m., 12:30 p.m. and 6:30 p.m. The
connection is automatically terminated after
auto time correction is complete.
Q2
Auto time correction is not performed
at a scheduled time.
Is auto time correction not being
performed according to its normal
schedule?
Note that auto time correction is not
performed for 24 hours after swapping of
the Home Time and World Time, or after
the time setting is corrected manually on
the watch. Auto time correction will
resume 24 hours after either of the above
operations is performed.
Is auto time correction enabled?
Auto time correction will not be performed
at the scheduled times if it is not enabled.
Enable auto time correction.
l
Using the Watch in a Medical Facility or
Aircraft
Q3
Time is not displayed correctly.
If your phone is unable to receive a signal
because you are outside its service range or
for some other reason, the watch may not be
able to display the correct time. If this
happens, connect the phone to its network
and then correct the time setting.
Q4
Hands are out of alignment.
Strong magnetism or impact can cause the
hands to go out of alignment. Adjust hand
alignment.
l
Adjusting Hand Alignment
●
Check the information below to find out how
to align the hands manually.
l
Hand Alignment Correction
Alarm and Hourly Time
Signal
Q1
An alarm does not sound.
Is the watch’s battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
l
Charging
Other than the above.
The alarm’s settings may not be
configured. Configure the alarm settings.
l
Configuring Alarm Settings
Q2
The hourly time signal does not
sound.
Is the watch’s battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
l
Charging
Other than the above.
The hourly time signal may be disabled.
Enable the hourly time signal.
l
Enabling the Hourly Time Signal
Hand Movement and
Indications
Q1
I don’t know what mode the watch is
in.
You can determine the current mode by
checking the mode hand position. Use (C) to
navigate between modes.
l
Navigating Between Modes
Q2
All hands are stopped and buttons do
not work.
The battery is dead. Keep the watch exposed
to light until it recharges sufficiently.
l
Charging
Q3
The hands suddenly start moving at
high speed.
This is due to the reason (or one of the
reasons) below, and does not indicate
malfunction. Simply wait until normal hand
movement resumes.
●
The watch is recovering from a power
saving state.
l
Power Saving Function
●
Watch is connected with a phone to correct
its time setting.
l
Auto Time Correction
Q4
[R] is flashing on the display.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q5
[CHG] is flashing on the display.
The charge level of the watch is extremely low.
Immediately expose the watch to light to
charge it.
l
Low Battery
Q6
Why is the current time indicated by
the watch is off by a certain amount
of time (nine hours, three hours and
15 minutes, etc.)?
The city setting is not correct. Select the
correct setting.
l
Setting a Home City
Watch Operation Guide 5729
29
To Next Page
Loading...
