Timing the First and Second
Place Finishers
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
D
B
D
B
2nd Finisher
1st Finisher*1
Split release*2
Start
*1
Displays the time of the first finisher.
*2
Displays the time of the second finisher.
Hours
Minutes Seconds
1/100 seconds
Minutes
3. Press (B) to reset the measurement time
to all zeros.
Using the Target Time Alert
Overview
You can specify a target time in 1-minute
increments up to 24 hours.
The watch beeps for 10 seconds when the
stopwatch measurement time reaches the
target time.
Specifying a Target Time
1. While the stopwatch elapsed time is reset
to all zeros, hold (A) for at least two
seconds. Release the button when the
hours digits start to flash.
2. Use (B) and (D) to change the target time
hour setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
Setting a start time of [0:00] performs a
countdown of 24 hours.
3. Press (C).
4. Use (B) and (D) to change the target time
minute setting.
5. Press (C).
6. Press (D) to toggle the target time alert
between enabled and disabled.
7. Press (A) to exit the setting screen.
Measuring Elapsed Time with the
Target Time Function
You can perform the same elapsed time
operations as those described in the sections
below.
l
Measuring Elapsed Time
l
Measuring a Split Time
Starting an elapsed time operation will cause
[TGT] to flash on the display.
An alert will sound for 10 seconds to let you
know when the elapsed time operation
reaches a target time you set.
Next, [TGT] disappears from the display.
●
The screen changes to show the
approximate elapsed time (in minutes)
compared to the target time.
Note
●
[TGT] will appear if you stop time
measurement while there is one or
more target time remaining.
Watch Operation Guide 5735
14
To Next Page
Loading...
