Stopping the Target Time Alert
While the target time alert is sounding, press
any button to stop it.
Note
●
Pressing (B) or (D) to stop the target
time alert also starts a stopwatch
elapsed time measurement operation.
l
Measuring Elapsed Time
l
Measuring a Split Time
Disabling the Target Time Function
1. While the stopwatch elapsed time is reset
to all zeros, hold (A) for at least two
seconds. Release the button when the
hours digits start to flash.
2. Press (C) twice.
This causes [On] or [OFF] to flash on the
display.
3. Use (D) to select [OFF].
4. Press (A) to complete the setting
operation.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Setting the Countdown Start
Time
The start time can be set in 1-minute units up
to 60 minutes.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the minutes
setting starts to flash.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Use (B) and (D) to change the timer
minutes setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
Minutes
Seconds
1/10 seconds
Minutes
2. Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (B).
3. Press any button to stop the tone.
Watch Operation Guide 5735
15
To Next Page
Loading...
