General Guide
EN-8
Perform the following procedure when you want to return the
Digital Piano’s stored data and settings to their initial factory
defaults.
1.
Turn off the Digital Piano.
2.
While holding down
(SONG BANK) and the
[1] 10-key (
) key at the same time, press
.
• Keep
(SONG BANK) and the [1] 10-key (
) key
depressed until the next step is complete.
3.
When the message “Pls wait” appears on the
screen, release
(SONG BANK) and the [1]
10-key (
) key.
•You will be able to use the Digital Piano in a short while
after its system is initialized.
• See “Turning on Power and Playing” (page EN-10) for
information about turning Digital Piano on and off.
Returning the Digital Piano to Its
Factory Default Settings
To Next Page
Loading...
