21
Programming automatic tax calculation
Important!
After you program the tax calculations, you also have to individually specify which departments
(page 28) and PLUs (page 34) are to be taxed.
For this cash register to be able to automatically register state sales tax, you must program its tax tables with tax calculation
data from the tax table for your state. There are two tax tables that you can program for automatic calculation of two
separate sales taxes.
State Sales Tax Calculation Data Tables
State sales tax calculation data tables for all of the states that make up the United States are included on the following pages. This
data is current as of October 30, 1994
*
. Simply find your state in the tables and input the data shown in its table.
*
Some data are revised after Oct. 30, 1994.
Important!
Be sure you use the state sales tax data specifically for your state. Even if your state uses the same tax
rate percentage as another state, inputting the wrong data will result in incorrect tax calculations.
To program Tax Tables
Example 1 Example 2
ALABAMA 6% COLORADO 5.25%
<Tax table 1> <Tax table 2>
ALABAMA
6%
0
1
1
8
24
41
58
STATE SALES TAX
CALCULATION
DATA TABLE
>
>
>
>
>
>
>
s
⁄n ¤n
‚n
fi°n
⁄n
⁄n
°n
¤›n
›⁄n
n
OW
A-A08
Mode Switch
Z
X
REG
OFF
RF
COLORADO
5.25%
5.25
5002
STATE SALES TAX
CALCULATION
DATA TABLE
<Tax table 1>
<Tax table 2>
>
>
s
⁄n ¤n
fi±¤fin
fi‚‚¤n
n
OW
A-A08
Mode Switch
Z
X
REG
OFF
RF
• If you enter a wrong data but have not yet pressed the n
key, press the C key to delete the wrong data.
•
If you have already pressed the n key, press the n key
once again to end the programming sequence and then start
a
To Next Page
Loading...
Need help?
General
