59
To program a PLU with single-item-sale status
☞ 1 After you press the c key, you can loop back and start programming for another PLU by inputting a new PLU number.
☞ 2 When you press the c key, you can loop back and input another specification which will be assigned to the next PLU.
☞ 3 Press the c key again to program the next PLU number with the same specification.
Sub-department/PLU specification
Treat as a PLU 2
‚
Treat as a sub-department 2 ⁄
A PLU can register its preset unit price
only. A sub-department can register its
preset price or a manually entered price.
Linked department
This specification links the PLU to a
department.
Department 1 2
‚⁄
Department 2 2 ‚¤
Department 3 2 ‚‹
Department 4 2 ‚›
Department 5 2 ‚fi
:
:
:
Department 36 2
‹fl
Department 37 2 ‹‡
Department 38 2 ‹
°
Department 39 2 ‹·
Department 40 2 ›‚
Non link 2 ‚‚
Input the total of a + b.
a. Do you want this PLU to be a single item
sale PLU or a normal PLU?
(Single-item-sale = 1/
Normal = 0) ----> a.________
b.Which tax table do you want to use for
automatic calculation of taxes?
See page 21 for information on setting up
the tax tables.
(Tax calculation) ----> b. _______
Tax table 1 2
¤
Tax table 2 2 ›
Tax table 1 and 2 2 fl
No tax calculation 2 ‚
to
PLU No.
Use all four digits
☞
1
☞
2
☞
3
⁄
fi‚‚
sp cs
OW
A-A08
Mode Switch
Z
X
REG
OFF
RF
To Next Page
Loading...
