EN-6
Power Outlet
After you finish assembling the stand, turn on the
Digital Piano. For details, see “Getting Ready” on page
EN-55.
1.
Press the 1P (Power) button to turn on
Digital Piano power.
• This causes the 1P (Power) button to light.
• If you press
1P (Power) button only lightly, the
display will light up momentarily but power will not
turn on. This does not indicate malfunction. Press
1P (Power) button firmly and completely to turn
on power.
2.
To turn off the Digital Piano, hold down the
1P (Power) button until its light goes out.
• You can configure the Digital Piano to save its setup
when power is turned off. For details, see
“Configuring Digital Piano Settings” on page EN-38,
and “General” 3 “Auto Resume” in the “Parameter
List” on page EN-42.
• Pressing the 1P (Power) button to turn off power
actually puts the Digital Piano into a standby state.
Minute amounts of current continue to flow within the
Digital Piano in the standby state. If you do not plan
to use the Digital Piano for a long time or if there is a
lightning storm in your area, be sure to unplug the
AC adaptor from the power outlet.
• The message “Please Wait...” will remain on the
display while a data save operation is in progress.
Do not perform any other operation while it is
displayed. Turning off the Digital Piano can cause
Digital Piano data to be deleted or become
corrupted.
This Digital Piano is designed to turn off automatically
to avoid wasting power after no operation is
performed for a preset amount of time. The Auto
Power Off trigger time is about four hours.
• You also can use the procedure below to temporarily
suspend Auto Power Off.
■ To disable Auto Power Off
1.
Press the 3SETTING button to display the
setting screen.
2.
Use the clw and q arrow buttons to
select “General” and then press the
cmENTER button.
3.
Use the clw and q arrow buttons to
select “Auto Power Off”.
4.
Use the clu and i arrow buttons to select
“Off”.
5.
Press the 3SETTING button to exit the
setting screen.
• To re-enable Auto Power Off, perform the above
procedure and select “On” in step 4.
1.
Use the 2VOLUME controller to adjust the
volume.
• Your Digital Piano has a Volume Sync Equalizer
feature that automatically enhances tone quality in
accordance with the volume level. This feature
ensures that low range and/or high range sounds
are easier to hear, even at low volume levels. For
details, see “General”3”Volume Sync EQ” in the
“Parameter List” (page EN-39).
Turning Power On or Off
Auto Power Off
Adjusting the Volume Level
z G e n e r a l > E n t
AP700-ES-1B.indd 8 2015/04/06 12:22:56
To Next Page
Loading...
Need help?
General
